自上料攪拌車轉向助力泵，我們通常把它叫做方向機助力泵，它是清障車轉向助力系統的動力源，也是轉向系統的心臟部分。對于重型清障車來說，由于機械式方向機，駕駛員操作勞動強度大，所以液壓轉向系統就更為重要。今天我們來了解一下自上料攪拌車助力泵維護細節。

The power steering pump of the self loading mixer is usually called the steering motor power pump, which is the power source of the steering power system of the obstacle removal vehicle and the heart of the steering system. For heavy obstacle removal vehicles, the hydraulic steering system is more important because of the mechanical steering gear and the driver's labor intensity. Today we will learn about the maintenance details of the booster pump of the self loading mixer.

一、在使用中如發現方向機助力泵滲漏，沖擊或有異常的噪音，應及時檢查排除。

1、 In case of any leakage, impact or abnormal noise found in the steering gear booster pump during use, it shall be checked and eliminated in time.

二、自上料攪拌車運行一段時間后，應及時更換液壓油幾濾芯，尤其是新泵裝車后使用2500-3000應更換液壓油。

2、 After the charging mixer has been running for a period of time, the hydraulic oil filter element shall be replaced in time, especially after the new pump is loaded and used for 2500-3000km.

三、定期檢查儲油罐的油平面，不足應及時補充清潔的液壓油，儲油罐內的濾芯應在保養時用酒精清洗干凈。

3、 Regularly check the oil level of the oil storage tank. If it is insufficient, clean hydraulic oil shall be replenished in time. The filter element in the oil storage tank shall be cleaned with alcohol during maintenance.

四、正確選擇液壓油是保證助力泵效率，延長壽命的關鍵。‘

4、 Correct selection of hydraulic oil is the key to ensure the efficiency and prolong the service life of booster pump‘

此外一些注意事項要多多來注意，比如：

In addition, pay more attention to some precautions, such as:

自動上料攪拌車使用時長達3個月時，同樣需要更換，不同企業的液壓油不能混合使用，更換液壓油時，油管、油管接頭、散熱器、液壓泵、液壓馬達需要清洗干凈，避免造成液壓馬達、液壓泵使用故障，延長壽命。

When the automatic feeding mixer has been used for 3 months, it also needs to be replaced. The hydraulic oils of different brands cannot be mixed. When replacing the hydraulic oil, the oil pipes, oil pipe joints, radiators, hydraulic pumps and hydraulic motors need to be cleaned to avoid the use failure of the hydraulic motors and hydraulic pumps and extend their service life.

維修調試噴油泵事，需要對行程余量進行檢查，以此判斷噴油泵是否需要進行調整，將柱塞與套筒的磨損降到低，駕駛員得要根據噴油泵的不同結構采用不同方法進行檢查。

For the maintenance and commissioning of the fuel injection pump, the stroke margin needs to be checked first to determine whether the fuel injection pump needs to be adjusted, so as to reduce the wear of the plunger and sleeve to a low level. The driver must use different methods to check according to the different structures of the fuel injection pump.

以上就是小編為大家介紹的自上料攪拌車助力泵維護的細節，在平常使用中記得多注意進行維護保養才能讓該設備的使用壽命有所增加，您還有什么問題或有什么需求就來我們網站http://www.dqpme.cn進行咨詢吧！

The above is the maintenance details of the booster pump of the self feeding mixer introduced by Xiao Bian. Remember to pay more attention to maintenance in ordinary use to increase the service life of the equipment. If you have any questions or needs, please come to our website http://www.dqpme.cn Consult!